Factory Bimini AFT DROP CURTAIN with Eisenglass window(s) zips to back of OEM Bimini-Top (not included) to Floor (Vertical, Not slanted to transom), OEM (Original Equipment Manufacturer) in Sunbrella® marine fabric, produced with the same high quality, original - digitized patterns approved by ® for the :
Notes: Zips onto back of OEM zippered Bimini-Top (Not included) and Bimini-Side-Curtains, and typically DROPS vertically from back edge of Bimini to the Floor. Curtain snaps to boat with Stainless steel Canvas-Snaps (which are included but not installed in the canvas) or Bunjis in some cases. Let us know if you need SS Snap-Stud-Screws to screw into the boat. The boat manufacturer and RNR-Marine™ do not recommend operating the boat with the aft-curtain in place, due to dangerous fuel and exhaust fumes.
TIP: Be sure to check your existing (and adjacent connecting) canvas pieces (and frames) for:
White (the tags are approx. 2-3 inches x 4-5 inches),
The ® logo embossed on the heads of the stainless canvas snaps,
The Zipper Size listed above (#8 in most cases) on all zippers.
Size/Fit: ONLY zips to Factory OEM Bimini-Top and Side-Curtains with Great Lakes® tags. Verify that your old and mating canvas has GREAT LAKES® on the tags and embossed on the Canvas Snaps AND factory #8 zippers (6 teeth/inch), NOT #10 (5 teeth/inch) which are After-Market zippers. The Bimini Aft-Curtain is NOT needed IF the boat has a Camper-Top and Camper-Aft-Curtain at the back. Stainless Steel Snaps included but NOT installed in canvas (to allow perfect alignment on install), need Snap Tool. Includes Zipper and Snap-Stud-Screws.
Will perform as described when installed properly,
Will completely satisfy you with the quality and construction.
You can count on all of the above or else the boat top or enclosure will be replaced or your money returned. Your boat is a large investment so be sure you protect it with the best marine canvas direct from the factory by RNR-Marine™ and Great Lakes Boat Top®