Purchase Camper Top Canvas and Frame AL (Factory OEM) part number [9ySR250 DA SN1-xxxxx-fcc] for 1995-1996 Sea Ray® 250 Sundancer 250DA Sundancer, NO Arch
Sea Ray, 250 Sundancer, 1995, Bimini Top, Bimini Visor, Bimini Side Curtains, Camper Top, Camper Top Side Curtains, Camper Top Aft Curtain, Starboard Rear.
Sea Ray, 250 Sundancer, 1995, Bimini Top, Bimini Visor, Bimini Side Curtains, Camper Top, Port side.
Sea Ray® 250 Sundancer shown with Camper-Top-Canvas-Frame-AL-OEM-G (additional canvas pieces or covers may also be shown above, click images to enlarge)
Factory Camper ALUMINUM FRAME and CANVAS with zippers for OEM Visor and Curtains, OEM (Original Equipment Manufacturer) in Sunbrella® marine fabric, produced with the same high quality, original 1995-1996 digitized patterns approved by Sea Ray® for the 250 Sundancer: 250DA Sundancer, NO Arch:
Notes:
1995-1996 Sea Ray® 250 Sundancer Model Specific Details: Aluminum top frames. The Cockpit Cover goes OVER the windshield and snaps at the base of the windshield in front. Sea Rays with 12-digit Hull Identification Number (HIN) beginning with SERA were made in Arizona for which we do NOT have OEM canvas patterns (this boat was built by Sea Ray in AZ and TN): our Tennessee Sea Ray® Bow Covers, Cockpit Covers and Carpet Runners we offer will fit Arizona boats, however the original Arizona top frame(s) were made by someone else, so our Tennessee Bimini, Sunshade and Camper replacement canvas will NOT fit Arizona frames, AND our Visor, Side or Aft Curtains will NOT zip properly to original Arizona top canvas, BUT ALL Arizona canvas AND frames can typically be replaced as a set, however we do NOT guarantee fit. Sea Ray® originally offered the 1995-1996 250 Sundancer in Royal Blue Tweed, Charcoal Tweed (1995), Teal Tweed, Dubonnet Tweed (1995) and Linen Tweed Sunbrella® (the Tops were originally SeaMark® vinyl-lined Sunbrella®, but are now Sunbrella® to avoid mold issues) fabric.
Product Details: Aluminum Camper-Top frame provides an enclosure attached to the back of a Bimini, Sunshade, Convertible Top or Arch that has its own frame to cover to the back of the boat. Includes mounting hardware and snaps. When combined with Curtains, the Camper-Top fully encloses the back of the boat providing full, protected use of the rear cockpit area at the dock or underway. Includes: Camper-Top tubular Framework (and Support Poles if used), Canvas, Fittings and mounting hardware (some Boat Manufacturers supplied their own hardware, so we don't supply it then). Camper-Top canvas has Zippers for Side-Curtains (and Aft-Drop-Curtain if so equipped). Factory Original-Equipment (OEM) canvas made-to-order.
Sea Ray® Factory Original Equipment Manufacturer (OEM) Notes: Zippers on Sea Ray® canvas are size #8 (6 teeth/inch) up to 35 foot, #10 over 35 foot (5 teeth/inch). Cockpit Covers for open bridge boats (Sundancer, SunDeck, SunSport, SLX, Bowrider, Express Cruiser, Weekender) prior to 2008 cover the windshield, 2008 and newer attach to Top of windshield. Embroidered Sea Ray® logo on SOME (when offered by Sea Ray) Boot Covers was Tan (gold) until 2011, then Silver 2012 and newer. Sea Ray® installed the snaps in their boats, canvas and covers at their factory, so we cannot install the canvas snaps for you because we do not have locations (see Canvas/Snap Installation to learn about installing snaps). We can only sell canvas and covers direct for Sea Ray® boats over 2 years old. Sea Ray® OEM canvas/covers part numbers: [yySRmmm mm tar-xxxxx-fcc] where [yy] is the model year, [SR] is Sea Ray®, [mmm mm] is the boat model, [t] is the type of window or drive (S=Std-Windshield, W=optional-stainless-Windshield, I=I/O-sterndrive, O=Outboard), [a] is (A)rch or (N)o-arch, [r] is the revision, [xxxxx] identifies which canvas piece, [f] is the fabric (A=Sunbrella® acrylic, S=SeaMark®) and [cc] is the color code. Sea Ray® Hull Identification Number (HIN) = SERpssssmbyy , where [p] = mfg plant, [yy] = model-year.
Factory OEM canvas: GLBT tags p/n [9ySR250 DA SN1 -xxxxx-fcc], Sea Ray® p/n [7xxxxx] or [8xxxxx]
TIP: Be sure to check your existing (and adjacent connecting) canvas pieces (and frames) for:
White GLBT tags p/n [9ySR250 DA SN1 -xxxxx-fcc], Sea Ray® p/n [7xxxxx] or [8xxxxx] (the tags are approx. 2-3 inches x 4-5 inches),
The GLBT p/® logo embossed on the heads of the stainless canvas snaps,
The Zipper Size listed above (#8 in most cases) on all zippers.
Factory Original-Equipment-Manufacturer (OEM) patterned for the {1995,1996} Sea Ray® 250 Sundancer: 250DA Sundancer, NO Arch.
Will ONLY fit and/or zip to other Factory OEM canvas/frames with GLBT tags p/n [9ySR250 DA SN1 -xxxxx-fcc], Sea Ray® p/n [7xxxxx] or [8xxxxx] ("cc" is the color code).
Attaches to the back of the Factory OEM Bimini, Sunshade or Convertible Top with its own frame.
100% Guarantee: We guarantee our mooring covers, bow covers, cockpit covers, bimini tops, camper tops, and other marine canvas enclosures
Will fit your boat to the specs provided,
Will match your existing GLBT canvas,
Will perform as described when installed properly,
Will completely satisfy you with the quality and construction.
You can count on all of the above or else the boat top or enclosure will be replaced or your money returned. Your boat is a large investment so be sure you protect it with the best marine canvas direct from the factory.
Warranty: This product is covered by the Manufacturer's Warranty.
Not what you need? Try:
