Factory Camper FRAME alone for OEM Camper-Top Canvas (not included), OEM (Original Equipment Manufacturer) , produced with the same high quality, original 1995-1996 digitized patterns approved by Sea Ray® for the 250 Sundancer: 250DA Sundancer, NO Arch:
Notes:
1995-1996 Sea Ray® 250 Sundancer Model Specific Details: Aluminum top frames. The Cockpit Cover goes OVER the windshield and snaps at the base of the windshield in front. Sea Rays with 12-digit Hull Identification Number (HIN) beginning with SERA were made in Arizona for which we do NOT have OEM canvas patterns (this boat was built by Sea Ray in AZ and TN): our Tennessee Sea Ray® Bow Covers, Cockpit Covers and Carpet Runners we offer will fit Arizona boats, however the original Arizona top frame(s) were made by someone else, so our Tennessee Bimini, Sunshade and Camper replacement canvas will NOT fit Arizona frames, AND our Visor, Side or Aft Curtains will NOT zip properly to original Arizona top canvas, BUT ALL Arizona canvas AND frames can typically be replaced as a set, however we do NOT guarantee fit. Sea Ray® originally offered the 1995-1996 250 Sundancer in Royal Blue Tweed, Charcoal Tweed (1995), Teal Tweed, Dubonnet Tweed (1995) and Linen Tweed Sunbrella® (the Tops were originally SeaMark® vinyl-lined Sunbrella®, but are now Sunbrella® to avoid mold issues) fabric.
Product Details: Camper-Top-Frame only (NO Canvas or Curtains). The Camper-Top-Frame is attached to the back (sometimes the front on Bow-Riders or Deck Boats) of a Bimini, Sunshade, Convertible Top or Arch that has its own frame. When combined with Curtains, the Camper-Top fully encloses the back of the boat providing full, protected use of the rear cockpit area at the dock or underway. Factory Original-Equipment (OEM) canvas made-to-order.
Sea Ray® Factory Original Equipment Manufacturer (OEM) Notes: Zippers on Sea Ray® canvas are size #8 (6 teeth/inch) up to 35 foot, #10 over 35 foot (5 teeth/inch). Cockpit Covers for open bridge boats (Sundancer, SunDeck, SunSport, SLX, Bowrider, Express Cruiser, Weekender) prior to 2008 cover the windshield, 2008 and newer attach to Top of windshield. Embroidered Sea Ray® logo on SOME (when offered by Sea Ray) Boot Covers was Tan (gold) until 2011, then Silver 2012 and newer. Sea Ray® installed the snaps in their boats, canvas and covers at their factory, so we cannot install the canvas snaps for you because we do not have locations (see Canvas/Snap Installation to learn about installing snaps). We can only sell canvas and covers direct for Sea Ray® boats over 2 years old. Sea Ray® OEM canvas/covers part numbers: [yySRmmm mm tar-xxxxx-fcc] where [yy] is the model year, [SR] is Sea Ray®, [mmm mm] is the boat model, [t] is the type of window or drive (S=Std-Windshield, W=optional-stainless-Windshield, I=I/O-sterndrive, O=Outboard), [a] is (A)rch or (N)o-arch, [r] is the revision, [xxxxx] identifies which canvas piece, [f] is the fabric (A=Sunbrella® acrylic, S=SeaMark®) and [cc] is the color code. Sea Ray® Hull Identification Number (HIN) = SERpssssmbyy , where [p] = mfg plant, [yy] = model-year.
Factory OEM canvas: GLBT tags p/n [9ySR250 DA SN1 -xxxxx-fcc], Sea Ray® p/n [7xxxxx] or [8xxxxx]
TIP: Be sure to check your existing (and adjacent connecting) canvas pieces (and frames) for:
White GLBT tags p/n [9ySR250 DA SN1 -xxxxx-fcc], Sea Ray® p/n [7xxxxx] or [8xxxxx] (the tags are approx. 2-3 inches x 4-5 inches),
The GLBT p/® logo embossed on the heads of the stainless canvas snaps,
The Zipper Size listed above (#8 in most cases) on all zippers.
Factory Original-Equipment-Manufacturer (OEM) patterned for the {1995,1996} Sea Ray® 250 Sundancer: 250DA Sundancer, NO Arch.
Will ONLY fit and/or zip to other Factory OEM canvas/frames with GLBT tags p/n [9ySR250 DA SN1 -xxxxx-fcc], Sea Ray® p/n [7xxxxx] or [8xxxxx] ("cc" is the color code).
Only fits specified boat.
Verify that your old and mating canvas has GLBT on the tags and embossed on the Canvas Snaps AND factory #8 zippers (6 teeth/inch), NOT #10 (5 teeth/inch) which are After-Market zippers.
100% Guarantee: We guarantee our mooring covers, bow covers, cockpit covers, bimini tops, camper tops, and other marine canvas enclosures
Will fit your boat to the specs provided,
Will match your existing GLBT canvas,
Will perform as described when installed properly,
Will completely satisfy you with the quality and construction.
You can count on all of the above or else the boat top or enclosure will be replaced or your money returned. Your boat is a large investment so be sure you protect it with the best marine canvas direct from the factory.
Warranty: This product is covered by the Manufacturer's Warranty.
Lead-Time (Estimated): We no longer sell this product.
Shipping Notes:
Signature required for delivery,
Can NOT ship to Post Office (PO) Box,
Can NOT change your address after order is placed,
Buyer is responsible for all Taxes, Duties and Tariffs imposed by local governments,
Use a US48 Based (in Florida, New Jersey or Oregon for example) Freight Forwarder to ship outside the USA or Canadian Provinces,
Check shipment for damage upon receipt and file claim with shipper.
International Shipments:
We do NOT ship Sea Ray Camper-Top-Frame-OEM-G1 Outside North America (continental United States 48 States (US48) and Canadian Provinces), Overseas: Use a US-based Freight Forwarder,
Please contact a Freight Forwarder (instructions) with an address in the US48 (Florida preferred for timeliness) to ship this for you,
Also note that the Freight Forwarders address must be added to your Credit Card to complete payment.
Not what you need? Try:
